TM
KOHNA TENT 18’ X 12’
MODEL 2000001188
To Set Up Tent’s Living Quarters (continued)
Before you begin
Read all instructions before set up.
7. Assemble 2 interlocking shock-corded, thin, gray side poles.
8. Insert gray side poles through sleeves, in front and back of
the living quarters area of tent as shown. (Fig. 3)
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
NOTE: Make sure the side poles are positioned on the
outside of the black main poles installed earlier.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
Fig. 3
Sleeve at back of
Living Quarters
Sleeve at front
of Living
Quarters
Parts and Components
Description
Living Quarters, Main Poles, Black (2)
Living Quarters, Side Poles, Thin, Gray (2)
Screen Room Poles, Gray (2)
Rainfly
Part Number
5010000384
5010000383
5010000382
5010000385
Thin, Gray,
Side Poles
To Set Up Tent’s Living Quarters
9. Insert one end of each gray side pole into pins in side of tent
forming an “X”. (Fig. 4 & Fig. 4A)
10. Go to opposite end of each pole and gradually apply pressure
to the pole forming an arch. Insert the pin into the pole end
at opposite side of tent forming an “X”. (Fig. 4)
11. Attach large frame clips along edges of upper four corners
tent to connect black main poles and gray side
1. Unfold tent and spread out on a clean, level surface with the
door facing the desired direction. (Fig. 1)
2. Assemble main tent poles by interlocking both longer, black
shock-corded, poles.
3. Insert black main poles through sleeves, in top of the Living
Quarters area of tent, forming an “X” as shown. (Fig. 1)
poles where they intersect. (Fig. 4 & 4B)
Fig. 1
Main Tent Poles
Sleeves
4B
Door
Living Quarters
Screen Room
4. Insert one end of each black main pole into pins in front
corners of tent. (Fig. 2 & 2A)
5. Go to opposite end of each pole and gradually apply pressure
to the pole forming an arch. Insert the pin into the pole end
at the tent corners. (Fig. 2 & 2A)
Fig. 4
4A
2A
To Set Up Tent’s Screen Room
1. Assemble screen room poles by interlocking both longer,
gray, shock-corded poles.
Fig. 2
2. Insert gray poles through both sleeves on screen room as
shown. (Fig. 5)
Sleeve at back of
Screen Room
Sleeve at front of
Screen Room
Door
6. Attach smaller frame clips along edges of
tent to black main poles.(Fig. 2B)
Gray Screen
Room Poles
NOTE: DO NOT attach the larger frame
clips located near the top of the tent living
quarters. They will be used in later assembly.
Fig. 5
2B
(continued on other side)
|
Compaq Projector iP 60E User Manual
Cooper Lighting Landscape Lighting 50 400W User Manual
Craftsman Drill 1372191 User Manual
Craftsman Saw 1132472T0 User Manual
Crosley Refrigerator 2212430 User Manual
Dell Server E21S001 User Manual
Dymo Printer 350D User Manual
Eagle Electronics Fish Finder 642c User Manual
Ecom Instruments PDAs Smartphones iroc x20 Ex User Manual
Freecom Technologies Computer Drive FHD xx User Manual